Most ford vehicles now come standard with a keyless entry remote control.
2008 ford fusion door lock problems.
If you are driving a 2008 ford fusion or if you are planning to purchase one then it is important that you review reported latches locks linkages problems and defects total reports.
The most recently reported issues are listed below.
Also the drivers door doesn t lock with the key fob.
The power door lock on the drivers side stopped working today all other locks are working.
However you can still set off the alarm while attempting to open the power.
Ford fusion owners have reported 4 problems related to power door locks not working under the electrical system category.
The rear passenger door central locking is no longer working either to lock or unlock.
Central locking problems finally a solution.
Info and repair ideas.
Average repair cost is 160 at 80 100 miles.
While driving with the automatic door lock engaged the force was so hard that it broke the driver side door handle.
Can you give an idea of how expensive it might be to fix this problem ford fusion se 2011.
It works fine when operated manually and you can hear something trying to work inside the door when you operate the remote but it doesnt actually man.
I have searched the net everywhere but the only thing i found was this.
The contact owns a 2008 ford fusion.
Many ford vehicles also provide an open trunk feature.
Issues in ford cars door locks and central lock system.
For the driver to get out of the car you need to roll down the drivers window and open the door from the outside.
The contact owns a 2008 ford fusion the contact stated that the door locks were not functioning properly.
Also please check out the statistics and reliability analysis of ford fusion based on all problems reported for the fusion.
Hi folks i have a problem with my wifes 08 plate fusion.
The 2008 ford fusion has 13 problems reported for door latch broke.
The contact also experienced the door.
Ford technical service bulletin tsb 05 10 21 says to clean any corrosion from the door latch connectors then pack them full of dielectric grease.
