2008 Dodge Nitro Blend Door Actuator Location

Remove the two screws that secure the blend door actuator to the actuator mounting bracket and remove the actuator.

2008 dodge nitro blend door actuator location.

Search fixya browse categories. I don t have a nitro so can t tell you if this procedure is correct. Disconnect the wire harness connector from the blend door actuator located on the driver side of the air distribution housing. I have a 2008 a dodge nitro.

The blend door is located in the air box under the dash and the actuator is located on the air box. Where is the heater blend door on a 2008 dodge nitro. If heater core is getting coolant circulating through it then you may have a temp blend door or blend door actuator not working properly. Where is the heater blend door in a 2008 dodge nitro heater blows cold air dodge 2008 nitro question.

My husband changed the thermostat and also flushed the he. Remove the two screws that secure the blend door actuator to the actuator mounting bracket and remove the actuator. At least that is what i assume. 2008 dodge nitro blend door.

If the actuator is tested off of the blend door it will simply turn. The defrost works but then you turn it to the vents it only blows cool air. Disconnect the wire harness connector from the blend door actuator located on the driver side of the air distribution housing. If both are hot then you might have a problem will the what they call a blend door actuator.

The actuators are on the side of the hvac housing forward and between the seats under the radio. Remove the two screws that secure the blend door actuator to the actuator mounting bracket and remove the actuator. The other one on the drivers side is the mode door vent floor defrost it it higher up and very close to the firewall. The blend door hot cold actuator is on the drivers side and closest to the seat.

And the heater is not working. 2008 dodge nitro air blend door acuater.